Oñesoluciona haguã descarga anormal extrusora gemelo, oñeikotevë oñentende principio de trabajo extrusora de tornillo gemelo.
The twin-screw extruder is one of the multi-screw extruders. It is developed on the basis of a single-screw extruder. In the barrel of the twin-screw extruder, two screws are placed side by side. Twin screw extruder. According to the relative position of the screw, it can be divided into meshing type and non-intermeshing type. The meshing type can be divided into partial meshing type and full meshing type. According to the direction of rotation of the screw, it can be divided into two types: the same direction rotation and the reverse rotation type. It can be divided into inward and outward. The nature of the co-rotating twin-screw pressure zone is different, and the material is rotated by the screw in the inner cavity of Pe manga ojejapo hagua petet zona de alta presión ha petet zona de baja presión. .

Mokõiha, upéicha pe extrusión extrusora gemelo ndaha’éi normal ikatu ha’e ko’ãva:
1. When the time is large, the feed is not smooth. If the solid raw material melts prematurely, it will stick to the screw, resulting in poor feeding or even material loss. This is the screw ring knot phenomenon that is usually said. Once the ring knot is generated, The most thorough solution is to pull out the screw and clean the glue at the feed end (the adhesive at the extrusion end does not Materia) ..
2. The temperature of the screw feed section is too high, which will cause ringing problems. If the screw has cooling water, the flow rate of the cooling water is too low, which may cause ringing problems. In addition, the screw needs to reach a certain speed to achieve a stable extrusion pressure, because there is a gap between the screw and the sleeve, and the rotation speed is too low, which may cause the molten material to flow back from the gap, causing ringing or Presión de extrusión fluctuación rehegua. .
3, materia prima iñambuéva, punto de ablandamiento ha punto de fusión iñambue, umi requisito proceso rehegua iñambue (temperatura iñambuéva) .
4. Pe grado de desgaste pe barril extrusora gemelo tornillo ha pe tornillo. pe barril ha pe tornillo oguerekóramo peteĩ desgaste tuicháva, omoheñóita descarga desigual térã ndohupytýi umi especificación ojeporúva normal..
